Grow Lights, Grow Tents and Hydroponic Systems
Mon-Fri: 10am - 8.30pm | Sat: 10am - 7pm | Sun 11am - 7pm

HAILEA Air Pump AC02201 – 78 lph


SKU: 10-455-230 Categories: , Tag:


Hailea ACO-2201

The Hailea ACO-2201 is a great value-for-money single output air pump. This pump produces a good air-flow of 1.3 litres/min – great for oxygenating your reservoir or driving an aquafarm.
  • Hailea – world famous for high quality aquarium air pumps
  • Produces an output of 1.3 litres per minute
  • Constructed with quality components for reliability
  • Rubber feet reduce vibration
  • Only 1.8 watts power consumption
  • Single output for driving one airline
  • Great for oxygenating your nutrient reservoir or for driving a waterfarm or aquafarm

The Hailea ACO-2201 is a budget single output air pump for pumping air through an airline and into a submerged airstone or for driving an aquafarm/waterfarm. Air is taken in on the underside of the unit and an
oscillating diaphragm pushes the air through the single output nozzle on the front of the unit. The air-pressure produced is good for the size of the unit and is very steady. Decent construction and special rubber feet on the unit reduce noise to a low level and power consumption is also very low at only 1.8 watts.

Place your air pump close to your reservoir on a flat, firm surface which is above the water level of the reservoir that you wish to aerate. Connect your air line onto the output nozzle, sliding it over the ridges until it is held on firmly. If it is difficult to push the air line on, softening the end of the air-line in warm water may make the job a lot easier. Fit your chosen airstone onto the other end of the air line and place it into the reservoir. It is best to try to keep the air line as short as possible because the air pressure will be reduced the longer it is. Plug the air pump into a mains outlet socket and switch it on. The air pump will now pull air in from the underside of the unit and push it out through the nozzle, down the air line and out through the airstone.

Always place your air pump at a height above the level of the water-line in the reservoir. If your air pump is at a height lower than the water-line and there is an unexpected power-cut or trip-out, water can siphon back from the reservoir into the air pump which will almost certainly cause it damage. We recommend the use of a check-valve (one-way or non-return valve) in the air-line as well to make doubly sure that back-siphoning cannot occur. Ideal for single or multi pot hydroponics systems or small tanks.

Technical Data

Model ACO-2201
Output 1.3L/min
Power 1.8W
Noise <40dB
Voltage 110/220V
Weight 0.23kg
Frequency 50/60Hz
Size 88x60x53mm
Pressure >0.012Mpa

Cart Item Removed. Undo

By continuing to use the site, you agree to the use of cookies. more information

The cookie settings on this website are set to "allow cookies" to give you the best browsing experience possible. If you continue to use this website without changing your cookie settings or you click "Accept" below then you are consenting to this.