Grow Lights, Grow Tents and Hydroponic Systems
Mon-Fri: 10am - 8.30pm | Sat: 10am - 7pm | Sun 11am - 7pm

HAILEA Air Pump AC02204 – 200 lph

£9.95

SKU: 10-455-230B Categories: ,

Description

Hailea ACO-2204

The Hailea ACO-2204 is a great value-for-money twin output air pump. This pump produces a good air-flow of 2 x 2.0 litres/min – great for oxygenating your reservoir or single pot systems. Hailea – world famous for high quality aquarium air pumps

Produces an output 2 x 2.0 litres per minute

  • Constructed with quality components for reliability
  • Rubber feet reduce vibration
  • Only 4 watts power consumption
  • Dual output for driving two airlines
  • Great for oxygenating your nutrient reservoir or for driving a waterfarm or aquafarm

The Hailea ACO-2204 is a budget twin output air pump for pumping air through two airlines and into submerged airstones or for driving aquafarm/waterfarms. Air is taken in on the underside of the unit and an oscillating diaphragm pushes the air through the two output nozzles on the front of the unit. The air-pressure produced is good for the size of the unit and is very steady. Decent construction and special rubber feet on the unit reduce noise to a low level and power consumption is also very low at only 4 watts.

Place your air pump close to your reservoir on a flat, firm surface which is above the water level of the reservoir that you wish to aerate. Connect your air lines onto the output nozzles, sliding them over the ridges until they are held on firmly. If it is difficult to push the air-lines on, softening the end of the air-lines in warm water may make the job a lot easier. Fit your chosen airstones onto the other end of the air-lines and place them into the reservoir. It is best to try to keep the air-lines as short as possible because the air pressure will be reduced the longer it is. Plug the air pump into a mains outlet socket and switch it on. The air pump will now pull air in from the underside= of the unit and push it out through the nozzles, down the air line and out through the airstone.

Always place your air pump at a height above the level of the water-line in the reservoir.  If your air pumps are at a height lower than the water-line and there is an unexpected power-cut or trip-out, water can siphon back from the reservoir into the air pump which will almost certainly cause it damage. We recommend the use of check-valves (one-way or non-return valve) in the air-line as well to make doubly sure that back-siphoning cannot occur.

Ideal for single or multi pot hydroponics systems or small tanks

Technical Data

Model ACo-2201
Output 2.0x2L/min
Power 4W
Noise <40dB
Voltage 110/220V
Weight 0.64Kg
Frequency 50/60Hz
Size 156x95x75mm
Pressure >0.02Mpa

Cart Item Removed. Undo
  • No products in the cart.