The LUMii SOLAR 315 is a complete fixture that powers a 315W LUMii SOLAR PRO lamp that will give your plants the best possible spectrum of light.
When it comes to growing a quality end-product, nothing quite compares to CDM lighting. This will show with healthier plants full of vigour leading to larger yields of better quality. The LUMii Solar 315w CDM Grow Light is bringing sunlight in doors! Whilst this is a high-end grow light, it comes in at a budget price, giving everyone the chance to take full advantage of CDM lighting.
- Full fixture light – ballast, reflector and lamp in one unit
- Integrated short circuit protection
- Can be used as a stand alone light or as a supplemental
- Extremely high levels of PAR (Photo synthetically active radiation)
- Highly efficient to run
- CDM lamps create superior plant usable light, like having sunshine indoors
- Lower heat output than standard HPS lighting
1x LUMii Solar 315w CDM Grow Light Fixture or 1x LUMii Solar 315w CDM Grow Light Fixture and 930 Pro Full Spectrum CDM lamp
Lumii Solar 315w Features:
• Short circuit protection
• Use for both supplementary and standalone lighting
• Extremely high PAR levels
• Lower heat output
• Super Efficient
Dimensions: 42cm x 27cm x 15cm
How Does the LUMii Solar 315w CDM Grow Light Work:
Ceramic discharge metal halide lamps are made with a ceramic arc tube instead of typical composites, like quartz. This allows the lamp to operate at higher temperatures. When the ballast ignites the gases within the lamp, the light it emits has a full spectrum that increases the growth and vigour. The LUMii Solar 315w CDM Grow Light reflects high levels of light down to your plants and spreads it evenly, thanks to the highly polished dimpled reflector.
Using the LUMii Solar 315w CDM Grow Light:
Simply position the light over the centre of your growing space. Always screw the lamp into the lamp-holder in your reflector as tightly as possible by gripping the lamp with a clean, dry cloth. If the lamp is not screwed in as tightly as possible, arcing can occur between the centre contact of the lamp and the lamp-holder. This melts the solder contact on the bottom of the lamp, causing damage and making it un-usable.
Connect the input lead of your reflector to the output lead of the ballast, ensuring the cable is not pulled tight and does not encounter anything hot (e.g. lamp, reflector, ballast).
The wattage of your ballast MUST match the wattage of the lamp you are using or there will be a high risk of fires or equipment damage. Connect the mains plug into an electrical outlet socket and switch on. The ballast will start-up and light the lamp.
Warning: 315w CDM lamps need to be bedded in as follows on their first use to avoid failure. Make sure you run the lamp on first ignition for at least 15 minutes. This will allow the metals within the lamp to fuse correctly.